Material Safety Data Sheet  BioBlend (R-Mod)

July 2004

A. Product Identification

Synonyms: RxP Dynamizer Blend In Soy Methyl Ester
Chemical Name: Mixture 
Chemical Family: Hydrocarbon & Soy Methyl Ester
Chemical Formula: Mixture 

CCAST Registration #: 31779 
Export Commodity Control #: 1C96G 

Products and/or Components Entered on EPA's TSCA Inventory: Yes, this product has been commercially introduced into U.S. commerce, and is listed in the Toxic Substances Control Act (TSCA) Inventory of Chemicals in Commerce; hence, it is subject to all applicable provisions and restrictions under TSCA 40 CFR, section 721 and 723.250. 

B. Hazardous Components

Ingredients: RxP Blend In Soy Methyl Ester
% By Weight: 100 
OSHA PEL: NE 
ACGIH TLV: NE 

NE - Not Established 
NA - Not Applicable 

C. Personal Protection Information

Ventilation: Use adequate ventilation. 

Respiratory Protection: Not generally required. In case of spill or leak resulting in unknown concentration, use NIOSH/MSHA approved supplied air respirator. 

Eye Protection: Use chemical goggles for splash protection. 

Skin Protection: Use impervious gloves. Use protective garments to prevent excessive skin contact. 

NOTE: Personal protection information shown in Section C is based upon general information as to normal uses and conditions. Where special or unusual uses or conditions exist, it is suggested that the expert assistance of and industrial hygienist or other qualified professional be sought. 

D. Handling and Storage Precautions 

Do not get in eyes, on skin, or on clothing. Avoid breathing vapors. Wear protective equipment and/or garments described in Section C if exposure conditions warrant. Wash thoroughly after handling. Launder contaminated clothing before reuse. 

Store in cool, well-ventilated area away from ignition sources. Provide means for controlling leaks and spills. Bond and ground during liquid transfer. Keep containers closed. 

E. Reactivity Data 

Stability: Stable 
Conditions to Avoid: Not Applicable 
Incompatibility (Materials to Avoid): Oxygen and strong oxidizing agents 
Hazardous Polymerization: Will not occur 
Hazardous Decomposition Products: Carbon oxides and various hydrocarbons formed when burned 

F. Health Hazard Data 

Recommended Exposure Limits: Not established.

Acute Effects of Overexposure 

Eye: May cause slight irritation.
Skin: May cause moderate to severe irritation. Requested skin contact may cause severe skin irritation reactions.
Inhalation: May cause irritation to nose, throat, lungs. Headache, nausea, dizziness and unconsciousness.
Ingestion: May cause irritation to intestines. Nausea, headache and unconsciousness. May be aspirated into lungs if swallowed resulting in pulmonary edema and chemical pneumonitis.

Sub-chronic and Chronic Effects of Overexposure: No known applicable information.

Other Health Effects 

Combustion: Normal use of EnviroFlame Fuel Dynamizer, results in an exhaust that has been associated with lung cancer in animals. There is limited evidence to suggest an association between occupational exposure to exhaust and lung cancer in humans.

Health Hazard Categories: 

What	Animal	Human
Known Carcinogen	NO	NO
Suspect Carcinogen	NO	NO
Mutagen	NO	NO
Teratogen	NO	NO
Allergic Sensitizer	NO	NO
Highly Toxic	NO	NO
Toxic	NO	NO
Corrosive	NO	NO
Irritant	YES	YES
Target Organ Toxin	YES	YES
Specify: Lung	Aspiration	Aspiration
	Hazard	Hazard
Skin & Eye	Freeze Burn	Freeze Burn
	Hazard	Hazard

First Aid and Emergency Procedures: 

Eye: Flush eyes with running water for at least fifteen minutes. If irritation develops, seek medical attention.
Skin: Wash skin with soap and water. If irritation develops, seek medical attention.
Inhalation: Remove from exposure. If illness or adverse symptoms develop, seek medical attention.
Ingestion: Do not induce vomiting. Seek immediate medical attention.

NOTE TO PHYSICIAN: GASTRIC LAVAGE USING A CUFFED ENDOTRACHEAL TUBE MAY BE PERFORMED AT YOUR DISCRETION. 

G. Physical Data 

Appearance	Amber Liquid
Odor	Mild
Boiling Point	350-650F (177-343C)
Vapor Pressure	1 mm Hg at 68F (20C)
Vapor Density	(Air = 1) Not Established
Water	Negligible
Specific Gravity	(H2O = 1) 0.80 at 60/60F (15.6/15.5C)
Percent Volatile by Volume	100
Evaporation Rate	(Butyl Acetate = 1) 1
Viscosity	Not Established

H. Fire and Explosion Data 

Flash Point (Method Used):	160F (71C) (TCC, ASTM D56)
Flammable Limits (% by Volume in Air):	LEL - Not Established
	UEL - Not Established
Fire Extinguishing Media:	Dry chemical, foam or carbon dioxide (CO2)

Special Fire Fighting Procedures: 

Evacuate area of all unnecessary personnel. Shut off source, if possible. Use NIOSH/MSHA approved self-contained breathing apparatus and other protective equipment and/or garments described in Section C if conditions warrant. If conditions immediately dangerous to life or health (IDLH) exist, use NIOSH/MSHA approved self-contained breathing apparatus (SCBA) equipment. Water fog or spray may be used to cool exposed containers and equipment. 

Fire and Explosion Hazards: Carbon oxides and various hydrocarbons formed when burned. 

I. Spill, Leak and Disposal Procedures 

Precautions Required if Material is Released or Spilled: 

Evacuate area of all unnecessary personnel. Wear protective equipment and/or garments described in Section C if exposure conditions warrant. Shut off source if possible and contain spill. Protect from ignition, Keep out of water sources and sewers. Absorb in dry, inert material. Transfer to disposal drums using non-sparking equipment. 

Waste Disposal (Insure Conformity with all Applicable Disposal Regulations): Incinerate or otherwise manage in a RCRA permitted waste management facility. 

J. DOT Transportation 

Shipping Name:	RxP Blend In Soy Methyl Ester
Hazard Class:	Combustible Liquid
ID Number:	NA 1993
Marking:	NA 1993
NMFC #:	155150
Class:	65
Label:	Combustible or Flammable
Placard:	None
Hazardous Substance/RQ:	Not Applicable
Shipping Description:	RxP Blend In Soy Methyl Ester
Packaging References:	49 CFR 173.150

K. RCRA Classification 

Unadulterated Product as a Waste Ignitable (D001) 

L. Protection Required for Work on Contaminated Equipment 

Use NIOSH/MSHA approved respiratory protection, such as air supplied mask, in confined spaces or other poorly ventilated areas. Wear protective equipment and/or garments described in Section C if exposure conditions warrant. Contact immediate supervisor for specific instructions before work is initiated. 

M. Hazard Classification 

__X__ This product meets the following hazard definition(s) as defined by the Occupational Safety and Health Hazard Communication Standard (29 CFR Section 1910.1200): 
__X__ Combustible Liquid 
_____ Compressed Gas 
_____ Flammable Gas 
_____ Flammable Liquid 
_____ Flammable Solid 
_____ Flammable Aerosol 
_____ Explosive 
__X__ Health Hazard (Section F) 
_____ Organic Peroxide 
_____ Oxidizer 
_____ Pyrophoric 
_____ Unstable 
_____ Water Reactive 
_____ Based on information presently available, this product does not meet any of the hazard definitions of 29 CFR Section 1910.1200. 

N. Additional Comments 

As of the preparation date, this product did not contain a chemical or chemicals subject to the reporting requirements of Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 and 40 CFR Part 372. 

EnviroFlame, Inc. (references to EnviroFlame, Inc. or EnviroFlame includes its divisions, affiliates and subsidiaries) believes that the information contained herein (including data and statements) is accurate as of the date hereof. NO WARRANTY OF MERCHANTABILITY, FITNESS FOR ANY PARTICULAR PURPOSE OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, IS MADE AS CONCERNS THE INFORMATION HEREIN PROVIDED. The information provided herein relates only to the specific product designed and may not be valid where such product is used in combination with any other materials or in any process. Further, since the conditions and methods of use of the product and information referred to herein are beyond the control of EnviroFlame, EnviroFlame expressly disclaims any and all liability as to any results obtained or arising from any use of the product or such information. No statement made herein shall be construed as a permission or recommendation for the use of any product in a manner that might infringe existing patents. 

Reviewed: January 2004